[. . . ] Children must get supervision to make sure that they do not play with the appliance. ⷠKeep children away from the appliance during and after the operation, until the appliance is cold. Remove all packaging, stickers and the protective layer of the stainless steel hob panel (if present) from the appliance before first use. ⷠDo not leave the appliance unattended during operation. [. . . ] Use the correct mains connection cable and replace the damaged mains cable with proper special cable. The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 millimetres. ⷠIf the fixing bracket is near to the terminal block, always make sure the connection cable does not come in contact with the edge of the bracket. ⷠYou must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), ground leakage trips and contactors. Manufacturer is not responsible for any injury to persons and pets or damage to property caused by failure to obey these requirements. ⷠMake sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. It has to be supplied with a correct plug, able to support the load marked on the identification plate. Any electrical component must be installed or replaced by the Service Force Centre technician or qualified service personnel. Make sure that there is an access to the mains plug after installation. The appliance must not be connected with an extension cable, an adapter or a multiple connection (risk of fire). Check that the ground connection is in conformity with the standard and regulations force. ⷠThe power cable must be placed in such a way that it does not touch any hot part. ⷠConnect the appliance to the mains with a device that lets to disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm, eg. ⷠNone of a parts of the connection cable can not get a temperature 90 °C. The blue neutral cable must be connected to the terminal block label with "N". The brown (or black) phase cable (fitted in the terminal block contact marked with "L") must always be connected to the live phase. Make sure that the cable section is applicable to the voltage and the working temperature. The yellow/ green earth wire must be approximately 2 cm longer than the brown (or black) phase wire. Before you install the appliance into cut out, put the sealing gasket on the edge of cut out. Kitchen unit with door The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. [. . . ] 1 Stick it on Guarantee Card and send this part 2 Stick it on Guarantee Card and keep this part 3 Stick it on instruction booklet These data are necessary to help you quickly and correctly. These data are available on the identification plate from the injectors kit. They are available at Service Force Centre and approved spare parts shops. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ]